AT90ADCPOD step by step configuration
Device specific settings
AT90S2333 or AT90S4433 running on internal clock or crystal on pod
- Connect your target application to the pod card using the 28 lead
probe cable inserted in connector marked 4433 2333.
- Use the 10 lead cable in connectors marked ADC and ADC28
- Jumper marked RST must be in position ON.
- Jumper marked S0 must be open and jumper marked S1 must be shorted.
- Jumper J104 and connector ADC40 are insignificant.
- Jumpers marked PB3 and PB4 are insignificant.
Your pod card is now properly configured.