AT90ADCPOD step by step configuration
Device specific settings
AT90S4414 or AT90S8515 running on internal clock or crystal on pod
- Connect your target application to the pod card using the 40 lead
probe cable inserted in connector marked 4414 8515.
- Jumper marked S0 must be shorted and jumper marked S1 must be open.
- Jumper marked RST must be in position ON.
- Jumper J104 and connectors marked ADC, ADC28 and ADC40 are insignificant.
- Jumpers marked PB3 and PB4 are insignificant.
Your pod card is now properly configured.