Volkswagen 01M Transmission. Manual - part 90

  

  

- Push new gasket - 1  - onto intake flange of oil strainer - 
2   -  and wet with ATF. 

The threaded studs M6 x 70 - arrows  - are needed to 
guide oil strainer. 

-  Install 3 threaded studs M6 x 70 into valve body by 
hand. 

- Place oil strainer onto threaded studs . 

-  Carefully press suction collar into opening at valve body 
up to stop.  

- Fasten bolts - arrows  - for oil strainer   

38-2, Torque 

specifications

 . 

-  Install oil pan 

 

38-1, Oil pan, removing and installing

 . 

-  After installation, fill with ATF, check ATF level, and top 
off  

37-4, ATF level, checking

 . 

Torque specifications

Oil strainer bolts

10 Nm

Page 2 / 2

ATF strainer, removing and installing

  

  

Automatic Transmission Hydraulic Pressure Sensor 
1 G193  and Automatic Transmission Hydraulic 
Pressure Sensor 2 G194  , removing and installing 

Senders must always be replaced together.

Special tools, testers and auxiliary items required

„

Torque wrench V.A.G 1410    

 

Removing

 

- If still installed, remove oil pan 

 

38-1, Oil pan, removing 

and installing

 and oil strainer 

 

38-2, ATF strainer, 

removing and installing

 . 

-  Carefully pull off connectors for Automatic Transmission 
Hydraulic Pressure Sensor 1 G193  - 1  - and Automatic 
Transmission Hydraulic Pressure Sensor 2 G194  - 2 - . 

-  Remove both sensors.  

Installing

 

Sensors must always be replaced together.

Page 1 / 2

Automatic Transmission Hydraulic Pressure Sensor 1 G193 and Automatic Transmissi...

Volkswagen Technical Site:   http://volkswagen.msk.ru   http://vwts.info   http://vwts.ru

            огромный архив документации по автомобилям Volkswagen, Skoda, Seat, Audi 

  

-  Install 2 new sensors and fasten to 5 Nm.

-  Push connectors onto sensors - 1  - and - 2  - up to 
stop. 

The connectors must engage.

-  Install oil strainer 

 

38-2, ATF strainer, removing and 

installing

 and oil pan 

 

38-1, Oil pan, removing and 

installing

 . 

-  After installation, fill with ATF, check ATF level, and top 
off  

37-4, ATF level, checking

 . 

Page 2 / 2

Automatic Transmission Hydraulic Pressure Sensor 1 G193 and Automatic Transmissi...

38 - 4 

  

 

Valve body, overview

The valve body and/or the lines can be removed and 
installed with transmission either removed or 
installed.

„

Solenoid Valve 2 N89    

„

Connector for Transmission 
Output Speed (RPM) Sensor 
G195  

„

The sensor is located behind 
valve body   

 

„

Automatic Transmission 
Hydraulic Pressure Sensor 2 
G194  

Page 1 / 4

Valve body, overview